EXFO FTB-1, User Manual

Page: 417 / 675

Test Results
NetBlazer
405
Summary (EtherSAM)
Summary (EtherSAM)
From the
Test
menu, tap
Results
, and the
Summary
tab.
Note:
For Dual Test Set , only Start Time is displayed on the remote module.

Service Configuration/Performance Test Status
indicates the actual
test status as follows:

Start Time indicates the date and time the test has been started. The
date and time is reset every time the test is restarted.

Remote unit in use and locked for Dual Test Set indicates that this
module is used for Dual Test Set as the remote module.
Test Status Description
“--” Test has not started.
Disabled Test/subtests is/are disabled.
Running Test/subtest is currently running.
Data Transfer Test/subtest is running but no test traffic is being transmitted.
Completed , <Verdict> Test/subtest has completed with the test pass/fail verdict. A
fail verdict is declared when a Link Down or LOS is detected,
or when any SLA parameter fails.
Aborted , < reason > Test/subtest has been aborted either manually (Stop) or
automatically from an alarm and the reason why the test has
been aborted is also displayed as follows:
Link down alarm , LOS alarm , Timeout during execution ,
DTS connection failed , Loss of remote connection (DTS) ,
LOPPS-L Alarm
a
, LOPPS-R Alarm
a
,
LOPPS-L / LOPPS-R Alarm
a
, Unresolved addresses ,
No test enabled , Invalid Burst Configuration ,
CIR disabled for all services , Excessive Refill Time
b
,
Stopped
a. Available for Dual Test Set in One-Way Latency measurement mode.
b. An excessive refill occurs when the pre-burst and/or post-burst duration last for
more than 2 seconds.