EXFO FTB-1, User Manual

Page: 237 / 675

Test Setup - Test Configurator, Timer, and System
NetBlazer
225
S-OAM and MPLS-TP OAM

Drop Eligible , available with S-OAM Mode or when VLAN is enabled
(see
VLAN
on page 190), is set to
No
(no frames will be dropped when
congestion occurs) and is not configurable.

Period
determines the transmission period of the CCM frame:
3.33 ms
,
10 ms , 100 ms (default), 1 s , 10 s , 1 min , or 10 min .
MPLS-TP Label Stack (G.8113.1)

MPLS-TP Mode
PW
(Pseudo-Wire) (default) provides an emulation of a point-to-point
connection over a packet-switching network. The PW begins and ends
at the LER or PE (Provider Edge).
LSP (Label Switch Path) is a path through a MPLS network, it begins
and ends at LER or LSR.
Section is a segment between two adjacent LER/LSR.

Label 2
check box when selected enables the MPLS Label 2. The
Label 2 check box is configurable for PW and LSP (cleared by default)
and is forced cleared for Section.

Label 1 check box when selected enables the MPLS Label 1.
The
Label 1
check box is forced selected for PW and LSP and forced
cleared for Section.

GAL
check box when selected enables the Generic Associated
Channel Label. The GAL check box is forced selected for LSP and
Section and is configurable for PW (selected by default).

Label is configurable for Label 1 and Label 2 : 16 to 1048575 , default
is
16
. Label is not configurable for GAL and is set to
13
.

TC sets the Traffic Class: 0 (default) to 7 .

TTL
sets the Time To Live:
1
to
255
, default is
128
.