5
REPONSE EN FREQUENCE: 20Hz~20KHz ±0.5dB (RIAA ±2dB)
DISTORTION HARMONIQUE : 0.01%
SEPARATION STEREO: > 45dB
RAPPORT SIGNAL/BRUIT: DJ MIC : 80dB
PHONO : 70dB
LINE/ CD : 85dB
CONTROLE DE TONALITE:
MIC & LINE 1-3
Boost/Cut@Center Frequency : ±12dB@100Hz, 1KHz, 10KHz
PHONO/CD
Boost@Center Frequency : +12dB@100Hz, 1KHz, 10KHz
Special Cut@Center Frequency : Aigu : -26dB@ au dessus de 10KHz
Médium : -26dB@ 1KHz
Basse : -26dB@ en dessous de 100Hz
TALKOVER : 0 à -20dB
INTERFACE USB
Conversion signal : Analogique
Digital ou Digital
Analogique : 16 bit
Lecture : Distortion : < 0.05%
Ratio Bruit : 80dB
Enregistrement : Distortion : < 0.1%
Interface : USB1.1 ou USB2.0, fonction lecture et enregistrement
DIMENSIONS : 482mm x 311mm x 115mm
POIDS : 5 kg
Attention: L'appareil ne doit jamais être en contact avec de l'eau ou tout autre liquide.
54IN816.011409
6
FRONT PANEL
1. DJ MICrophone Input
A Combination XLR & 1/4“ jack sockets mounted on the front face of the mixer for
connecting your microphone and offer both balanced or unbalanced microphone
connections.
2. Input Selector
Each music input channels has two input options. This switch lets you select which of
the inputs plugged into the channel you wish to use. All input channels are dual with
Channel MIC/LINE 1,2&3 and Channels PHONO/CD 1&2.
3. GAIN Controls
Correct setting of the controls for input GAIN for every channel is crucial for getting a
good, strong signal without noise or distortion.
4. MIC & LINE1-3 Channel EQ
All Microphone channels & channel LINE 1-3 have a 3-band equalizer for tone
shaping. The EQ controls have fixed frequencies and a boost/cut range of +/- 12dB.
5. Music Channel EQ
All music channels have a 3-band equalizer for tone shaping. The EQ controls have
fixed frequencies and a boost/cut range of +12/-26dB.
6. TALKOVER Control
When the Master microphone is activate all other inputs will be automatically
attenuated. This control pre-sets the level of which the main music program will be
attenuated.
Attenuation range: 0dB (OFF) to 20dB.
To disable the override facility, simply turn the control fully clockwise.
