EXCURSION SX-10D4, Owner'S Manual

Page: 5 / 12

4
If you are intending to use mul ple subwoofers in your system, EXCURSION
recommends having seperate chambers for each subwoofer if the subwoofers
will be operated by different amplified signals. This prevent possible cancella on.
WARNING: The use of silicone rubber to seal in a speaker will void the Warranty!
If sealing is needed to the speaker gasket, use caulking cord or vinyl weather strip.
IMPORTANT: Never cut any metal that is an integral part of an automobile`s
safety or structural support system.
NOTE: EXCURSION strongly recommends that you operate the complete audio
system at low volume before final installa on of your SHX Series Subwoofers.
This will allow a trial listening test to set maximum volume without distor on.
CAUTION: Make sure that all speaker wiring is fully protected from cu ng
or wear. Any short circuits developing as a result could severaley damage
the radio unit or amplifier. Make sure that all speaker wires easily reach the
speaker terminals without stress on the wire or connectors.
PREPARING FOR INSTALLATION
Note: The tools listed below may be required for proper installa on.
* An elec ric drill with drill bits
* Phillips-head and standard screwdrivers
* Crimping tool and needle-nose pliers
* Silicon sealant or closed cell weather-stripping
* Metal file, Hole saw, Tin Snips, Wire strippers
INSTALLATION PRECAUTIONS
Note: Proceed only if you are a qualified installer otherwise let your dealer do it.
* Always wear protec ve eyewear when using tools
* Turn OFF all stereo and other electrical devices before you begin
* Disconenect the (-) nega ve lead from your vehicle`s ba ery.
* Keep the speakers in the package un l final installa on.
* Locate fuel lines, brake lines, oil lines, electrical cables when planning installa on.
* Check to see clearance behind the moun ng surface before installing speakers.
* When running speaker wires through sheet metal, be sure to use gromments
to properly insualte the wires from metal edges.