3
EXCURSION
These RCA Input jacks connect with your source unit RCA Low Level Outputs.
The use of highquality twisted pair car audio cables is recommended to mind
possibility of disturbance the audio signal.
1. RCA Audio Input
2. GAIN Control
The Gain controle will match the amplifiers sensitivity to the provided source unit signal voltage.
3. X-Over Mode Swit
4. HIGH PASS FILTER Control
5. LOW PASS FILTER Control
This know controls the frequency x-over point from where Low Frequency can be cut out.
gh and low FQ rom your audio signal.
These RCA Audio Output Jacks offer the possibility to route the audio signal to further Amplifier.
Helpful for example if Headunit offer only one pair RCA Output and further SXA Amplifier need
share same Signal. The use of them are to compare with Y-RCA Adapters
The Volume of your SXA Amplifier can get comfortable adjusted from driver seat.
This knob adjust 45Hz signal BOOST level from 0 up 12dB. Preferable demand small size cars.
This LED will light up when amplifier works properly
This LED will light up if amplifier has detected a fault or has shut down to protect itselves.
This may caused for example at excessive heat, reverse polarity, short circuit or overload.
This case please turn off the amplifier, disconnect and resolve the problem before continue.
This LED will light up when the signal starts clipping and support best settings of GAIN.
This Terminal is to connect directly to the frame of vehicle. Use shortest distance possible and
equal or larger AWG OFC Cable size than +12V Battery Cable. Asure frame cleaned to bar metal.
This Remote terminal is to connect with headunit 12V remote output to turn ON/OFF the amplifier
according operating of headunit. If there are more amplifier connected to this terminal it might be
necessary, depending on REM performance of headunit, to install an additional relay.
6. RCA Audio Output
7. REMOTE - Bass Level Controle (included)
8. BASS BOOST Level
9. POWER Indicator
10. ALARM Indicator
11. CLIPPING Indicator
12. GROUND Terminal
13. REMOTE Terminal
This know controls the frequency x-over point from where High Frequency can be cut out.
