Exclusive Brands Smart Glider, Manual, Page: 14 / 16

NOTE- Only the indicator light on the charger will tell you the status of the battery during charging.
10. Safety Alerts
During operation, if there is a system error or illegal operation performed with your Smart Glider, the
system cannot enter self-balancing mode, so the device will prompt the user in a variety of ways. You
will notice the Running Indicator Light will turn RED and you will hear a beep sound alerting you to take
precaution and cease operation.
The following are common occurrences where you will hear the Safety Alerts; these notices should not
be ignored, but appropriate action be taken to correct any illegal operation, failure or errors.

Prohibited riding surfaces (Ex. High volume water.)

When you step on the Smart Glider, if the platform is tilted more than 10 degrees forward or
backward.

Battery voltage is too low.

The device is still charging.

During operation, the platform self-initiates to tilt due to excess speed.

Overheating, motor temperature is too high.

The device has been rocking back and forth over 30 seconds.

System enters protection mode, the alarm indicator will light up and buzzer will alarm (this
typically occurs when the battery is about to die).

If the platform is tilted forward or backward more than 35 degrees, Smart Glider will power off.

If the tire is blocked, Smart Glider will stop after 2 seconds.

When the battery level has depleted below protection mode, the Smart Glider engine will
power off after 15 seconds.

While sustaining a high discharge current during operation (such as driving up a steep slope for a
long period of time), the Smart Glider engine will power off after 15 seconds.
11. Inspection, Maintenance, and Storage
Your Smart Glider requires routine inspection and maintenance. This chapter describes maintenance
steps and important operating tips.
Before you perform the following operations, ensure the power and charging cable is disconnected.
1. Inspecting and Cleaning your Smart Glider:

Disconnect the charger and turn off your Smart Glider.

Routinely check the body of the Smart Glider and tires for damage or excessive wear.

Avoid using water or other liquids and cleaners on the Smart Glider for cleaning.