E X C E L D R Y E R , I n c .
P h o n e 1 . 8 0 0 . 2 5 5 . 9 2 3 5
s a l e s @ e x c e l d r y e r. c o m
E a s t L o n g m e a d o w, M A
F a x
1 . 4 1 3 . 5 2 5 . 2 8 5 3
w w w. e x c e l d r y e r. c o m
P A G E 4
INSTALLATION INSTRUCTIONS
for dryer with 40102 control
(CONTINUED)
Step 2-12.
Attach the HEPA Filter Adapter (A) with Control in the
spot where the air inlet cover was removed, using the
three (3)
screws previously removed in Step 2-3. Make sure to route the wires
through the HEPA Filter Adapter slot so that they are not pinched
(especially in the areas indicated in
Figure 2-16
). It may be necessary
to adjust the position of the HEPA Filter Adapter until it is flush with
the dryer housing. The HEPA Filter Adapter will not be positioned
flush to the dryer until the screws are tightened. The foam seal on
the back of the HEPA Filter Adapter will compress against the casing
of the motor.
Figure 2-16
40525
Step 2-13.
Take the HEPA Filter (B) out of the clear sealed plastic wrap
and insert the Filter into the HEPA Filter Adapter (A).
DO NOT touch
the white filter media, as this can result in reduced performance
and efficiency.
The side with the foam gasket around the perimeter of
the filter should be placed into the HEPA Filter Adapter first. Position
the filter so that the label is facing away from the wall as shown in
Figure 2-18
. Fasten the filter to the HEPA Filter Adapter with the
two
(2)
screws previously removed in Step 2-2 (
Figure 2-17
).
Figure 2-17
Step 2-14.
Orient the HEPA Pre-Filter (G) so that the label is facing the
same direction as the HEPA Filter Label, then push on the corners of the
metal frame so that it fully clips into place. The clips will fall into square
cutouts in the metal frame of the HEPA Pre-Filter
(Figure 2-18
). Replace
dryer cover, carefully avoiding pinching any wires, then restore power to
check for proper function.
Affix Retrofit Label (I) to outside of cover, on the lower right side.
Installation is now complete
Figure 2-18
White
Filter
Media
Two screws to
fasten Filter
Three screws
Adapter slot
Check for
wire pinching
HEPA Filter Label
END OF INSTRUCTION FOR #40102 CONTROL. PROCEED TO PAGE 5 IF YOUR HAVE CONTROL #40103
