29
CHECKS
Make sure to keep the controller clean while protecting it from rain or water. Never hose off
your power scooter or place it in direct contact with water.
Keep wheels free from lint, hair, sand and carpet fibers.
Visually inspect the tire tread. If less than 1mm(1/32”), please have your tyres replaced by
your local dealer.
All upholstery can be washed with warm water and mild soap. Occasionally check the seat
and back for sagging, cuts and tears. Replace if necessary. Do not store your scooter in
damp or humid conditions as this will lead to mildew and rapid deterioration of the
upholstery parts.
All moving mechanism will benefit from simple lubrication and inspection. Lubricate using
petroleum jelly or light oil. Do not use too much oil, otherwise small drips could stain and
damage carpets and furnishings etc. Always perform a general inspection of the tightness
of all nuts and bolts.
RHINO controller: Your scooter is fitted with a Rhino controller, which continuously monitors
the operating conditions of your scooter. If it detects a problem it will indicate with error
message by flashing light on the power ON/ OFF light. You must count the number of the
flash, and see the list to check what kind of error has happened according to the number)
Number of
Flashes
Fault
Impact
on
Scooter
Notes
1
Battery needs
recharging
Will drive
Battery charge is running low. Recharge the
batteries as soon as possible.
2
Battery
voltage
too
low
Drive
inhibited
Battery charge is empty. Recharge the batteries. If
the scooter is left off for a few minutes, battery
charge may recover sufficiently to allow driving for a
short period of time.
3
Battery
voltage
too
high
Drive
inhibited
Battery charge is too high. If a charger is plugged in,
unplug it or turn the Charge/Run switch to Run.
Scooters powered by RHINO will charge the
batteries
when
traveling
down
slopes
or
decelerating. Excessive charging in this manner may
cause this fault. Turn the scooter power off and then
back on again.
4
Current limit
time out
Drive
inhibited
The scooter has drawn too much current for too long,
possibly because the motor has been over worked,
jammed or stalled. Turn the scooter power off, leave
