5
SOFTENER INSTALLATION AND USER GUIDE
BARRIE
●
ONTARIO
●
CANADA 705.733.8900 WWW.EXCALIBURWATER.COM
1.7)
Brine Line Connection
Install 3/8” O.D. Polyethylene tube according to specification sheet from the brine tank to the control
valve.
1.8)
Overflow Line Connection
•
Only used where brine tank overflow water spillage can damage flooring or structure.
•
Brine tank is equipped with safety float valve which prevents the overflow in case if control
valve fails to control the refill cycle.
•
In case if safety float also fails to stop refill then only the water will come through overflow line
connection.
1.9)
Drain Line
•
The ½” tubing must be used for drain line.
•
Leave minimum of 6” gap between flow control fitting and solder joints. The gap less than this
can damage the flow control.
•
If the drain line is elevated and then emptied into the drain below the level the of control valve
then 7” loop should make at the end of drain line.
•
The air gap between the drain and the end of the drain line must be twice the diameter of the
tube.
•
The drain line must be clamped or strap tied at the end to secure in position.
Tank Brine Line
Connection
Brine Line
Drain Line
