Page | 13
Remote Control Setup
The e18 DAC is pre-programmed to work with the supplied remote control. If you like, you can
reprogram the e18 DAC to work with a different IR remote control. The exaSound e18 DAC can be
trained to recognise commands from most infrared remote controls using Sony and NEC IR protocols.
Use the following procedure to change remote control button assignments or to pair the e18 DAC with a
different remote control:
1.
Power on the e18 DAC. Make sure that the unit is not in
playback mode.
2.
Press the
Setup
button.
3.
Press the
Volume Up
button to confirm the remote control
programming mode, or press the
Volume Down
button to
cancel the operation.
4.
Point the remote control to the e18 DAC display. Press and hold
down the remote control buttons for about one second during
each step below to assign functions to them.
5.
Press the remote control button you want to use for increasing
the volume.
6.
Press the remote control button you want to use for decreasing
the volume.
7.
Press the remote control button you want to use for selecting
the next input.
8.
Press the remote control button you want to use for previous
input.
9.
Press the remote control button you want to use for turning the
unit on and off.
10.
Press the remote control button you want to use for mute.
11.
Wait until the remote control configuration is saved. Your e18
DAC is now paired for with the new IR remote control.