5.3.2 Adjusting the park position
1.
Place the motor lever loose on the shaft, parking right or left (see drawing in paragraph
3.4 and below for reference);
2. Place the motor lever in such a way that it forms an almost straight line with the
connection lever (see drawing);
3. Tighten the motor lever well and place the wiper in the bulkhead;
4. Run the motor briefl y to check performance;
5. Install the wiper arm in correct parking position.
Nut M8
Tightening 17Nm/12ft. lbs
Retaining Ring
Dogbone
Half Nut M8
Tightening 17Nm/12ft. lbs
Drive Shaft
Pin
Nordlock
Bearing
Motorlever
Dogbone
Washer
Nordlock
Nut M6
Tightening 6.8Nm/5ft. lbs
Nordlock
Nut M10
tightening 33Nm/24ft. lbs
Bolt M6x25
Nordlock
Half Nut M10
tightening 33Nm/24ft. lbs
Nut M10
tightening 33Nm/24ft. lbs
Bolt M10x35
(4x)
Top mount
RH/Pt Park position
Bottom mount
LH/Stb Park Position
Top mount
RH/Pt Park position
Bottom mount
LH/Stb Park Position
Top mount
RH/Pt Park position
Bottom mount
LH/Stb Park Position
Correct
Not correct
Correct
Not correct
14
MANUAL WIPER SYSTEMS