2
EXAKT PT Ltd. 2010
cover, insert the torx key into the blade retaining screw
and unscrew clockwise.
(Diagram C)
b)
Depress the guard to remove the blade.
c)
Place the new blade onto the blade shaft ensuring
the hole locates correctly and the teeth point
forwards in the direction of the curved arrow.
(Diagram C)
d)
Replace the safety retaining washer and tighten the
screw.
(Diagram D)
e)
Remove both keys before plugging in.
Guard Removal
NOTE: Do not use without the Guard.
a)
Ensure the tool is unplugged from the power supply.
b)
Unscrew the guard release screw. Slide off the
guard.
(Diagram E)
NOTE: When replacing the guard the blade can
protrude through the slot in the base plate. To
avoid injury ensure that the hand is kept well
clear. Ensure the guard is replaced the correct
way round.
Clamping
It is not normally necessary to clamp the material
being cut as long as it is fully supported on a work
surface and held with one hand. Clamping should be
used where;
The operator is inexperienced in the use of power
saws or weak handed
Small parts or tough material is to be cut.
Cutting Limitations
There is no limitation on the size of material that can
be cut as long as it is fully supported.
The saw will cut up to ½” deep. Material up to twice
as thick can be cut if cutting is performed on both
sides.
Holding and Switching On
Holding the tool correctly will result in easier and safer
operation, with less fatigue.
Right handed operator:
(Diagram F)
D
E
B
C
