NX2200e User Guide
© 2016 ExaDigm, Inc.
Page 8 of 18
Rev. 3/0316
8.0
Powering Terminal
9.0
Card Entry
Insert Smart Card into the reader slot below key pad.
9.1
NFC
10.0
Modem Configurations
Ensure that the terminal is connected to an active power source or has a fully charged battery in it.
10.1
CDMA
Before you use the terminal to do live transactions with TCP/IP connections, you need to make sure the
modem is activated. Contact your network carrier, ISO or ExaDigm to confirm activation.
10.2
HSPA
Before you use the terminal to do live transactions with TCP/IP connections, you need to make sure the
modem is activated by inserting the SIM card. Contact your network carrier, ISO or ExaDigm to confirm
activation.
10.3
Ethernet
Connect the Ethernet cable to the Ethernet port (LAN) on the side of the terminal.
10.4
WiFi
Connect the WiFi USB stick to the USB port on the side of the NX2200e.
Swipe card through reader with the magnetic stripe
facing down and toward the terminal.
To power on terminal press orange Power key
until beep is heard. The boot up process will
display.
To power down terminal press orange Power
key briefly then press ENTER to complete
process.
Press [ENTER] key to
power off!!
Other keys to cancel.
Gently place the NFC Card
above the screen or
slowly swipe across toward the keypad.
