eXact PipeCut P1000, Operating Instructions Manual

Page: 15 / 19

Operation English
14
Cutting result adjustment on Exact PipeCut P1000
Adjusting the alignment of the blade
CAUTION!
Blade alignment adjustment is very
effective and can lead to blade and/or saw damage if
adjusted too much.
Before making the adjustment, note the bodyplate
alignment (FIGURE L / 1), in case it is needed to return
back to the original setting.
Loosen the two screws securing the bodyplate
FIGURE L / 2. Turn the bodyplate to the required
direction using the adjustment screw (FIGURE M / 3)
and secure the two screws. Make only small
adjustments at a time.
If the cutting line goes from right to left (FIGURE K/a),
turn the bodyplate clockwise (FIGURE M / 1).
If the cutting line goes from left to right (FIGURE K/b),
turn the bodyplate counterclockwise (FIGURE M / 2).
CAUTION
! The adjustment indicator located in the back
of the adjustment plate does give the exact
measurement to adjust. The indicator shows only the
direction of adjustment and the category of magnitude.
Vacuum cleaner duct
To keep the working area clean and prevent plastic
from melting, the pipe saw is equipped with an
attachment for a vacuum cleaner. It is recommended to
always use vacuum cleaner attached to the pipe cut
machine.
Vacuum cleaner duct is always open and no other
action than attaching the vacuum cleaner hose is
needed to use this option (FIGURE N).
FIGURE L
FIGURE M
FIGURE N