Exabyte 221L, Product Manual

Page: 145 / 208

A
UGUST
2005 E
XABYTE
221L
AND
221L-FC L
IBRARIES 129
I
SSUING
L
IBRARY AND
T
APE
D
RIVE
C
OMMANDS
6.
6. 6.
6. If the destination is a tape drive and you want the cartridge loaded into the
drive, check the Load tape drive box.
7.
7. 7.
7. Click on the Move Cartridge button.
8.
8. 8.
8. When finished, return the library to its original control mode.
R
UNNING
L
IBRARY
D
IAGNOSTIC
T
ESTS
You can perform the following diagnostic tests to check individual library
functions:
Continuously scan bar code labels – The robot scans all of the cartridge
slots.
Continuously pick and place a cartridge – The robot takes a cartridge from
a specified element and replaces it in the same location.
Continuously cycle an axis – The robot moves on the specified axis: X axis
(robot moves right and left), Wrist (robot rotates from front to back), and
Picker (the robot’s cartridge gripper moves in and out without a cartridge).
Continuously cycle a solenoid – The solenoid that locks the door or the
entry/exit port opens and closes.
Continuously Scanning Bar Code Labels
To test bar code label scanning:
1.
1. 1.
1. Set the library’s control mode to Remote (see page 92 ).
2.
2. 2.
2. Click on Maintenance at the top of the page.
3.
3. 3.
3. Click on Perform library diagnostic tests.
!
! !
!
Important
If you insert a data cartridge into a tape drive, be aware that the
drive will not automatically eject the data cartridge. However, if
you insert a cleaning cartridge into a tape drive, the cartridge will
be ejected when the cleaning is finished.