Exabyte 221L, Product Manual

Page: 108 / 208

92
P
RODUCT
M
ANUAL
1014258
C
HAPTER
6—U
SING THE
R
EMOTE
M
ANAGEMENT
U
TILITY
S
ETTING THE
R
OBOT
C
ONTROL
M
ODE
The robot control mode determines which interface controls the robot. Refer
to page 54 for descriptions of the available robot control modes.
To set the robot control mode:
1.
1. 1.
1. Click on Configure at the top of the page.
2.
2. 2.
2. Click on Set the robot control mode. A page similar to Figure 6-3 appears.
3.
3. 3.
3. If necessary, enter the remote manager password (see page 105 ).
4.
4. 4.
4. Click on the radio button for the new control mode.
5.
5. 5.
5. Click on the Change button. The new control mode takes effect.
C
ONFIGURING THE
I
NTERFACES
From the Remote Management utility, you can configure the library’s SCSI,
Fibre Channel, network, and serial interfaces.
Configuring the SCSI Interface (221L)
For the 221L, you can set the SCSI IDs for the library and tape drive(s) and
enable or disable SCSI parity checking. See page 32 for information about SCSI
IDs. See page 33 for information about SCSI parity checking.
Figure 6-3 Remote management utility – Robot Control Mode Configuration page