Exabyte 221L, Product Manual

Page: 114 / 208

98
P
RODUCT
M
ANUAL
1014258
C
HAPTER
6—U
SING THE
R
EMOTE
M
ANAGEMENT
U
TILITY
Configuring the Serial Interface
For the library’s serial interface, you can specify the baud rate. You can use the
serial interface for upgrading firmware and creating diagnostic listings. See
page 143 for information about using the library’s serial interface.
To set the baud rate for the library’s serial interface:
1.
1. 1.
1. Click on Configure at the top of the page.
2.
2. 2.
2. Click on Configure the interfaces.
3.
3. 3.
3. Click on Configure the serial interface. A page similar to Figure 6-10
appears.
4. 4. 4. 4. If necessary, enter the remote manager password (see page 105 ).
5. 5. 5. 5. Click the radio button for the new baud rate.
6. 6. 6. 6. Click on the Change button. The change takes effect.
C
ONFIGURING THE
L
IBRARY
From the Remote Management utility, you can specify settings for the
following system options:
Emulation mode
Bar code scanning
Maximum number of addressable slots
Sequential mode
WWN override for tape drives
Library security
Remote manager security
Automatic tape drive cleaning
Figure 6-10 Remote management utility – Serial Interface Configuration page