E
XABYTE
110L, 221L,
AND
221L-FC
I
NSTALLING
OR
R
EPLACING
A
T
APE
D
RIVE
1
B
EFORE
Y
OU
B
EGIN
3
OF
8
C
ONTENTS
OF
THE
T
APE
D
RIVE
K
IT
The tape drive kit contains one of the following LTO Ultrium tape drives
pre-installed in a drive carrier:
4
SCSI LTO Ultrium 1
4
SCSI LTO Ultrium 2
4
Fibre Channel LTO Ultrium 1
4
Fibre Channel LTO Ultrium 2
P
REPARING
FOR
R
EPLACEMENT
1.
1.
1.
1.
Obtain a #2 Phillips screwdriver.
2.
2.
2.
2.
Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD). If possible, use an antistatic mat and
grounded static protection wristband during installation. If a mat and
wristband are not available, touch a known grounded surface, such as a
computer’s metal chassis.
3.
3.
3.
3.
Power off the library or autoloader and disconnect the power cord.
Important
If you are upgrading a 221L library from SCSI to Fibre Channel
or from Fibre Channel LTO Ultrium 1 to Fibre Channel LTO
Ultrium 2, contact Exabyte Technical Support (1-303-417-7792)
to determine whether your library needs additional hardware
upgrades.
Important
Before powering off the library or autoloader, make sure it is not
communicating across the SCSI bus. Powering off the library or
autoloader may disrupt communication on the SCSI bus.
Important
Before performing this procedure, be sure that the power switch
is in the off position and the power cord is disconnected from
the outlet.