E
XABYTE
110L, 221L,
AND
221L-FC
I
NSTALLING
OR
R
EPLACING
A
T
APE
D
RIVE
4
I
NSTALLING
THE
N
EW
T
APE
D
RIVE
7
OF
8
4
I
NSTALLING
THE
N
EW
T
APE
D
RIVE
1.
1.
1.
1.
Insert the tape drive so that the handle is at the left and the fan is at the
bottom, as shown in
. The tape drive should slide easily toward the
front of the library.
2.
2.
2.
2.
Tighten the captive screw to 8.0 inch-pounds (9.2 kg-cm) of torque.
3.
3.
3.
3.
Connect the cable(s) and terminator, if used, to the new tape drive.
Note:
If you are installing an additional tape drive in the 221L or 221L-FC,
refer to the
221L and 221L-FC Product Manual
for information about
connecting to SCSI or Fibre Channel.
4.
4.
4.
4.
Reconnect the power cord and power on the library or autoloader.
Calibration of the new tape drive occurs automatically during power on.
Figure 5
Sliding a tape drive into the library (221L shown)
Caution
To avoid damaging the tape drive, make sure the library or autoloader is powered
off when you connect it to the SCSI bus.
Important
Do not power on the 221L or 221L-FC library with an empty
drive bay. Each drive bay must have either a tape drive or a
service access cover.