Ex-Cell VR2500, Operation Manual

Page: 12 / 16

12- ENG
A08955
4. Add *RV antifreeze to hose as
shown.
5.
Pull engine starter rope slowly
several times until antifreeze
comes out of high pressure hose
connection of pump.
6. Remove garden hose from water
inlet of pump.
7. Reconnect spark plug wire.
*Windshield washer fluid may also be
used
1. Obtain a funnel , six ounces
of *RV antifreeze, and 16 - 36
inches of garden hose with a
male hose connector attached to
one end.
Use only RV
antifreeze. Any
other antifreeze is corrosive and
can damage pump.
2.
Disconnect spark plug wire.
3. Connect length of garden hose to
water inlet of pump.
STORAGE
ENGINE
Consult the Engine Owners Manual for
the manufacturer's recommendations
for storage.
PUMP
The manufacturer recommends using
a pump protector/winterizer, such as
EXA80, when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. If a pump
protector/winterizer is not available,
*RV antifreeze needs to be run through
the pump as outlined in the steps
below.
NOTE:
Using a pump protector/winterizer
or *RV antifreeze is to provide proper
lubrication to the internal seals of the
pump regardless of temperature or
environment.
ACCESSORIES PANEL
The accessories panel was designed
to hold several accessories that can
be purchased separately at the store
where this pressure washer was
purchased.