6
ADJUSTABLE WINDOW SLIDER KIT
The adjustable window slider kit is installed as shown below.
WATER DRAIN
When the air conditioner is used, excess water condensation may be produced that will
fill the water tank. This water is captured by an internal container. When this is full, the
unit will stop working and the “FULL” indicator will illuminate.
This means the unit will need to be drained as follows:
1. Switch off and unplug the unit.
2. Move the unit to a suitable location to drain the water. Consider placing a small
tray beside the outlet pipe to catch the drained water.
3. Remove the drain plus as per the image below. (Fig. 2)
4. Slightly tilt the unit to the rear to drain the water.
5. Replace the drain plug. Ensure the drain plug is fully fitted before use. Connect
the exhaust hose to the window kit before the unit is switched back on.
7
MAINTENANCE
WARNING: ALWAYS UNPLUG THE UNIT BEFORE MOVING OR CLEANING.
CLEANING
Air filters
The air filters are located on the left and right side of the unit. To remove the air filters,
please follows the arrow directions below by pulling out the filters in an upward
direction. Clean only with warm soapy water.
Cabinet
As with filters, clean only with warm soapy water.
CARE OF THE UNIT
1. Only plug the unit into a suitable 220-240V~ 50Hz AC 10 AMP power supply.
2. Hold the plug when unplugging the unit, never pull on the cord.
3. Do not place the unit in direct sunlight. This can fade the plastic case.
4. Do not operate the unit in a confined space.
5. Do not place objects on top of the unit. This blocks the air outlet.
6. Do not place the unit where the air inlets or outlets may be blocked by curtains or
furniture.
7. Keep the filters clean.
