Design and function
MMA welding
099-005613-EW501
23.04.2019
33
5.5 MMA welding
CAUTION
Risk from electrical current!
If welding is carried out alternately using different methods and if a welding torch and
an electrode holder remain connected to the machine, the open-circuit/welding voltage
is applied simultaneously on all cables.
• The torch and the electrode holder should therefore always be placed on an insulated
surface before starting work and during breaks.
For connection description, see the relevant “Power source” operating instructions.
5.5.1 Welding task selection
For selection of the welding task and for general operation see the relevant Control operating instructions.
5.6 Remote control
The manufacturer's warranty becomes void if non-genuine parts are used!
• Only use system components and options (power sources, welding torches, electrode hold-
ers, remote controls, spare parts and replacement parts, etc.) from our range of products!
• Only insert and lock accessory components into the relevant connection socket when the ma-
chine is switched off.
Remote controls are used for the remote operation of various machine functions (see operating instruc-
tions for remote control). Depending on the machine design, the remote control connection can be 7- or
19-pole (connection see chapter Machine description
> see 4 chapter
).
Figure 5-18
Item Symbol Description
0
1
Remote control
• Insert the remote control connector plug into the wire feeder remote control connection (19-pole) and
lock by turning to the right.
