Design and function
Cooling module assembly/disassembly
099-008598-EW501
04.04.2016
17
5.4
Cooling module assembly/disassembly
Assembly and disassembly is very simple and doesn't require any tools.
Figure 5-1
• Open out all four screw connectors on the cooling module as far as they will go.
• Position the welding machine precisely with the machine's feet in the openings of the screw
connectors provided on the cooling module.
• Push all four screwed connectors back in as far as they will go.
WARNING
Risk of accidents due to screw connectors that are not locked!
Attention must be paid to cleanliness and correct installation
when mounting a power source with a cooling module. The
cooling module could become loose if not properly mounted,
thereby causing serious injuries.
• Remove dirt from the feet of the power source's unit and the screw
connectors of the cooling module before mounting.
• Check that the connections are locked in place before each
transport
(push the screw connections back in as far as they will go)!
CAUTION
Damage due to supply lines not being disconnected!
During transport, supply lines which have not been disconnected (mains supply leads,
control leads, etc.) may cause hazards such as connected equipment tipping over and
injuring persons!
• Disconnect supply lines!
