Functional characteristics
Advanced functions
Item No.: 099-008088-EWM01
11
5.2
Advanced functions
5.2.1
Manual remote control R20
5.2.1.1
Program changeover
Set "Program or up/down mode" changeover switch on the welding machine or wire feed unit to
the "Up/down mode" position!
• Change between up to ten (0 to 9) welding programs.
• Welding programs are created using the control on the welding machine or wire feed unit. (see
operating instructions for the relevant machine, chapter "Main program mode A")
Operating
element
Action Result
Display
Select next or previous welding program.
5.2.2
R40 manual remote control
5.2.2.1
Program changeover
• Change between up to 16 (0 to 15) welding programs.
• Welding programs can be created using the control on the welding machine or wire feed unit or using
the remote control itself. (see operating instructions for the relevant machine, chapter "Main program
mode A", or the chapters following these instructions)
Operating
element
Action Result
Display
Select next or previous welding program.
P0 : 7.6M +1.1V
...
P0 : 7.6M +1.1V
5.2.2.2
Program limit
• The maximum number of retrievable welding programs can be limited.
Operating
element
Action Result
Display
Switch off the welding machine.
+
+
Hold down "Mode" button on the remote control,
switching on the welding machine.
PROGRAMME: 0XX
Set program number.
PROGRAMME: 0XX
Switch off the welding machine and restart in
order to put the change into effect.
