15
Ewbank, 38 Bluestem Road, Ipswich, Suffolk, IP3 9RR Tel. 01473 271 272
OPERA
TING INSTRUC
TIONS
ATTENTION
Dry running of more than 2 minutes leads to damage of the high-pressure pump. If the appliance
does not build up pressure within 2 minutes, switch the appliance off and proceed in accordance
with the instructions in the “Troubleshooting” section of the instruction manual
HIGH PRESSURE OPERATION
CAUTION
Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to avoid
damage.
CAUTION
Make sure the power switch is set to “OFF” before inserting the plug into a properly installed
socket.
ATTENTION
• The washer must be used on a secure and stable surface
1. Connect the product to power and water supply as described.
i. Open the water supply
ii. Hold the high-pressure gun with both hands
iii. Direct the nozzle of the chosen accessory away from you towards the surface to be
cleaned
iv. Unlock the trigger and press it until a constant amount of water flows through the nozzle,
to allow air trapped in the hose to escape
v. Release the trigger
vi. Turn the power switch from “OFF” to “ON”
vii. Hold the spray gun with both hands. Direct the water jet to the object to be cleaned
and press the trigger
viii. Release the lever of the high-pressure gun; the device will switch off again and stop the
water jet. High pressure remains in the system
WARNING! Beware of kickback when pressing the trigger!
