22
WT.050.580.001.DE.IM.0714
Installation
Sensor measuring modules for MFC
4.
4.6
Mounting the housing covers
1
Ensure that the cable bushes are fitted correctly.
2
Carefully place the electronic module cover. Make sure that
the sensor cables are in the cable conduits.
Fasten with five housing screws.
3
Carefully place the housing cover onto the flow block
assembly and snap into place.
4.7
Switching the unit on
The unit is not equipped with a mains switch and is in operation as
soon as the electronic module housing cover has been fit and the
supply voltage is applied.
When entering operating data, please note that these could
directly influence the connected system components!
Please note
The installed sensors must be calibrated with the run-in times in
mind. See Instruction Manual „MFC” "Operation, Commissioning
and Calibration".
Depending on the application set up on the MFC, the settings for
the controller outputs, measuring ranges, limit values, etc.
must be made after the sensor measuring modules have been
installed (see Instrcution Manual „MFC”).
Summary of Contents for Wallace & Tiernan W3T158761
