5. Installation
DEPOLOX® 400 M
38
EN
5.
Installation
5.1
Scope of delivery
The scope of delivery includes the following,
depending on the version selected:
•
400 M electronics module (module name
E02)
•
Flow cell (module name D02) or Y-style
flow-through
•
DEPOLOX® 5 C
non-pressurized or pressurized version
•
VariaSens C
non-pressurized or pressurized version
•
Y-style flow-through assembly
non-pressurized version
•
Sensor measuring module:
•
TC3 (total chlorine)
•
FC2 (free chlorine)
•
CD7 (Chlorine dioxide)
•
OZ7 (Ozone)
•
pH
•
ORP (Redox)
•
Fluoride
•
LED glow stick (pre-wired)
•
Multi-sensor (pre-wired)
•
DIN rail
•
Assembly accessories
•
Instruction manual
5.2
Transport and storage
Transport
The DEPOLOX® 400 M disinfection analyzer is
shipped in standard packaging. During trans-
port, the packaged DEPOLOX® 400 M must be
handled carefully and should not be exposed
to wet weather or moisture.
Check that the transport packaging is unda-
maged. In the event of damage, please inform
the transport company immediately, as your
rights to compensation will otherwise be lost.
If a component is damaged, please contact
your affiliate immediately.
Keep the packaging until the system has been
commissioned and put into operation.
Storage
Electronics module, flow cell, Y-style flow-
through and sensors must be stored in dry
condition without any residual water in a dry
place that is not exposed to the elements.
Shut-down
The DEPOLOX® 400 M may only be taken out
of operation by trained and authorized per-
sonnel.
5.3
Required ambient conditions
•
The DEPOLOX® 400 M must be protected
against moisture, rain, frost, heat and
direct sunlight and may therefore not be
installed outdoors.
•
Do not use the DEPOLOX® 400 M in envi-
ronments where there are flammable
gases, fumes or dust or conductive dust.
•
Do not subject the DEPOLOX® 400 M to
strong shocks or vibrations.
•
The air in the room must be non-conden-
sing.
5.4
Mechanical Installation
NOTICE
Correct and safe operation can only be gua-
ranteed if the requirements for the ambient
conditions are met. All applicable national
and local regulations must be observed!
WARNING
Risk of injury or damage to the installation!
•
Only authorized and qualified electrici-
ans are permitted to install the DEPO-
LOX® 400 M.
•
All electrical work on the DEPOLOX®
400 M must be carried out by authorized
and qualified electricians.
•
Modifications to the device other than
those described in this operating manual
are not permissible.
