background image

4

EVONIC - 104 INSTRUCTION MANUAL ISS. 11

EVONIC - 104 INSTRUCTION MANUAL ISS. 11

 IMPORTANT INFORMATION AND HEALTH & SAFETY

When using electrical appliances, basic precautions should always be followed to reduce 
the risk of fire, electric shock, and injury to persons, including the following:

•  Read all of the instructions carefully before using the appliance, only use this appliance 

as described in this manual. Any other use not recommended by the manufacturer may 

Any other use not recommended by the manufacturer may 

cause injury to persons, or damage to the appliance.

cause injury to persons, or damage to the appliance.

•  Remove all packaging and dispose of it at an appropriate recycling facility.
• 

•  When transporting or storing the appliance and power lead, keep in a dry place, away 

When transporting or storing the appliance and power lead, keep in a dry place, away 
from excessive vibration and store so as to avoid damage.

from excessive vibration and store so as to avoid damage.

•  This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot 

surfaces. The trim around the heater outlet becomes hot during heater operation. 
DANGER: High temperatures may be generated under certain abnormal conditions.

•  Do not install this appliance immediately in front of a fixed socket outlet.
•  Do not install this appliance in the immediate surroundings of a bath, shower, 

swimming pool or any other area where the appliance could come into contact with 
water or humidity, e.g. a bathroom.

• 

•  Do not use in areas where gasoline, paint, or any flammable liquids are used or stored. 

Do not use in areas where gasoline, paint, or any flammable liquids are used or stored. 

•  This appliance is only suitable for indoor use, do not use outdoors.
•  Do not cover the appliance, or let the air inlet/outlet to be obstructed in any way as it 

may overheat.

•  Keep the power lead away from hot surfaces and the heater outlet. Do not route the 

power lead in front of the appliance, or under any carpets or rugs. Do not allow the 
power lead to be coiled up once installed, as this can cause overheating.

•  A maintenance hatch must be installed into the surrounding installation to allow future 

access.

•  Always use a certified electrician should new circuits or outlets be required. And 

always use properly grounded, fused and polarised outlets.

•  Where the power lead passes through any masonry wall, stone surround etc. ensure 

that suitable rubber bushes are fitted at any possible wear points.

•  If the power lead is damaged do not use the appliance until it has been replaced.
•  Do not use any external switching device, timers, or extension leads. Do not connect 

the appliance to a circuit that is frequently switched on and off by the utility.

• 

•  In the event of a malfunction, switch off the appliance, and disconnect it from the 

In the event of a malfunction, switch off the appliance, and disconnect it from the 
mains power supply. Have the appliance inspected by a certified electrician before 

mains power supply. Have the appliance inspected by a certified electrician before 
reusing.

reusing.

•  Do not use the appliance if it is damaged. In the event of any damage to the appliance, 

please contact the retailer from whom the appliance was purchased.

•  Any repairs must only be performed by a certified electrician. 
•  Extreme caution is necessary when any heater is used by, located near children or 

people of reduced mobility, and whenever the unit is left operating and unattended.

•  Young children should be supervised to ensure that they do not play with the appliance.
• 

•  Disconnect from the power supply before performing any cleaning, maintenance or 

Disconnect from the power supply before performing any cleaning, maintenance or 
relocation of the unit. Do not use steam cleaners, or aerosols near the appliance.

relocation of the unit. Do not use steam cleaners, or aerosols near the appliance.

•  Do not burn wood or anything else in this appliance.
•  Do not strike the glass. The glass used is toughened safety glass, if broken it will 

shatter into small chunks which are less likely to cause injury.

•  Do not drill or screw any new holes into the appliance.

Summary of Contents for DOUBLE SIDED E1030 DS



















Reviews: