Error Messages
The DNA 200 will indicate a variety of error states.
Check Atomizer:
The DNA does not detect an atomizer, the atomizer has shorted out, or the atomizer
resistance is incorrect for the power setting.
Shorted:
The atomizer or wiring are short circuited.
Weak Battery:
The battery needs to be charged, or a higher rate battery needs to be used. If this
happens, the DNA 200 will continue to fire the atomizer, but will not be able to provide the desired
wattage. The Weak Battery message will continue to flash for a few seconds after the end of puff.
Temperature Protected:
The heating coil reached the maximum allowed temperature during the puff. If
this happens, the DNA 200 will continue to fire, but will not be able to provide the desired wattage.
Ohms Too High:
The resistance of the atomizer coil is too high for the current wattage setting. If this
happens, the DNA 200 will continue to fire, but will not be able to provide the desired wattage. The
Ohms Too High message will continue to flash for a few seconds after the end of puff.
Ohms Too Low:
The resistance of the atomizer coil is too low for the current wattage setting. If this
happens, the DNA200 will continue to fire, but will not be able to provide the desired wattage. The
Ohms Too Low message will continue to flash for a few seconds after the end of puff.
Too Hot:
The DNA 200 has onboard temperature sensing. It will shut down and display this message if
the internal board temperature becomes excessive.
Auto power down
The screen will be at full brightness while firing. After 10 seconds with no button presses, the screen will
dim. 30 seconds after the last button press, the screen will fade out and the device will go into sleep
mode. To wake the device, press the fire button.
