19
www.evolutionpowertools.com
EN
Note:
The top blade guard is equipped with a dust extraction
port
(Fig.21).
• Connect the supplied dust extraction hose to the top blade
guard. The hose is a ‘push fit’ onto the extraction port.
• Connect the other end of the hose to the 2 way connector
found to the rear of the machines main body.
(Fig. 22)
Note:
The ‘free’ port of the 2 way connector can be used to
attach a workshop dust extraction machine to this Evolution
machine. If such a machine is connected to this Table Saw
follow the Instructions provided by the supplier/manufacturer
of the dust extraction equipment.
Use of such equipment will ensure that the workplace is kept
clean and tidy, and that dust is kept to a minimum.
OPERATION
ON/OFF SAFETY SWITCH
WARNING:
Before operating the switch make sure that the
blade guard is correctly installed and operating properly.
To start the machine, lift the safety cover (
Fig. 23)
to reveal
two buttons.
• Push the ‘ON’ button to start the machine.
• Push the ‘OFF’ button to stop the machine.
WARNING:
Never start the machine until all safety checks and
procedures have been carried out.
RAISING/LOWERING THE BLADE
WARNING:
Only make adjustments to the machine when the
machine is switched OFF and the blade is stationary.
Note:
This machine is equipped with a dual function
hand- wheel
(Fig. 24)
in its ‘normal’ (outer) position this
hand-wheel is used to raise or lower the blade.
Fig. 21
Fig. 22
Fig. 23
Fig. 24