___________________________________________________________________________
Table T-Slot Spec
:
Page 1: ... 5mm Guard ID 28 5mm OD 35 5mm __________________________________________________________________________ Adjust 90 Degree Stop Loosen this bolt to adjust the 90 degrees stop ___________________________________________________________________________ Table Dimension Without table extensions W 560 mm x D 580 mm With table extensions W 900 mm x D 580 mm Hight without legs H 290 mm ...
Page 2: ...e adjustable rip fence with the T Slot and hold in place C Pull or push the clamp end to make it parallel with the slot D Then holding the rip fence in place with one hand Lock the rip fence green handle E Re tighten the cap screws 2 Blade Adjustment A First remove the Blade guard B Slide the rip fence up to the blade and check it is parallel C If not parallel remove the table insert This is a Phi...
Page 3: ...2A B 2C 2D 2E ...
Page 4: ...___________________________________________________________________________ Table T Slot Spec ...
