Evolution 005-0001, Original Instructions Manual

Page: 10 / 32

10
www.evolutionpowertools.com
MOUNTING EVOLUTION MITRE SAW TO THE MITRE STAND
Note:
The Evolution Mitre Saw Stand is suitable for most
Evolution Mitre Saws.
• Remove and safely store the four (4) plastic feet from
underneath the base of the mitre saw.
(Fig. 10)
• Remove and safely store the stability block from
underneath the positive stop locking lever.
(Fig. 11)
• Attach the machine to the saw mounting brackets
(A)
using
suitable bolts, washers and locknuts etc. The locking handles
must be positioned to the front of the mitre saw.
(Fig. 12)
• Ensure that the fixings used do not protrude so far through the
base of the machine that they interfere with any other parts of
the Mitre Saw. Only tighten ‘finger tight’ at this stage.
• Hook the front of the brackets over the front of the mitre
saw stands main frame tubular crossbar.
(Fig. 13)
• Push the back of the brackets down to engage them onto
the mitre saw stands crossbars.
(Fig. 14)
• Lock the brackets into place by gently depressing the
locking levers. (Fig. 15)
• If necessary re-postion the mitre saw on the brackets so
that the machines fence aligns as near centrally with the
rear tubular crossbar of the mitre stand as possible. This will
ensure the greatest stability of the machine and mitre saw
stand during cutting operations.
• When the mitre saw is correctly positioned on the stand,
securely tighten the four (4) mounting bolts.
Fig. 10
Fig. 11
Fig. 12
Fig. 13 Fig. 14 Fig. 15