Evoke EFL660W, Owner'S Manual, Page: 7 / 11

1. Open the drawer and add adequate detergent into main wash compartment marked “ ” or “ ”.
2. Add the fabric softener into compartment marked “ ” or “ ” .
Do not exceed the maximum level mark.
3. Close the drawer.
How to use washer How to use washer
Use process Use process
1. Sort the laundry by colour and by care label. Most garments have a
textile care label in the collar or side seam.
2. Make sure all the pockets are empty, Foreign objects (e.g. nails, coins,
paper clips, etc.) can cause damage to garments and components in
the machine.
3. Close any zips, fasten hooks and eyes etc before washing.
4. Dark textiles often contain excess dye and should be washed separately
several times before being included in a mixed load. Always wash whites
and coloureds separately.
5. Badly soiled areas, stains etc. should be pre-treated with liquid detergent,
stain removers etc.
6. Turn over the clothes which pill easily and is with woolen surface before
putting them into the machine.
Unfold the laundry and load loosely in the drum. Mixing both large and small items gives better
wash results and also helps distribute the load evenly during spinning. The most efficient use of
energy and water is achieved when a full load is washed. However, do not overload as this causes
creases and reduces cleaning efficiency.
Make sure that no garments are nipped between the
door and the seal.
It can remove the water out which left in the tub because of manufacturer’s checking out.
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do these:
1.Connect the power and turn on the tap.
2.Press the “Power” button ,then turn the knob to position “Cotton
”.
3.Press “Start/Pause”.
Washing preparation
1.Connect the inlet hoses well and turn on the tap.
2.After making sure the power socket is grounded reliably, insert the power plug into the power
socket.
3.Place the drain hose well.
Preparation of clothes
Put clothes into the washer
Using the detergent drawer
The right amount to dispenser will depend on the following:
The quantity of laundry
The soiling level of the laundry
- Lightly soiled
No visible dirt or stains. Possibly slight body odour.
- Normally soiled
Visibly dirty and/or just a few slight stains.
- Heavily soiled
Visible dirt and stains and/or dried on soiling.
The water hardness level.
It is recommended to use low foaming powder for all washing temperature programs.
Washing steps
1.Turn on the water tap, and connect the power.
2.Open the door, and put the cloth into the drum one by one.
3.Close the door, and put suitable amount of detergent and fabric softener into the dispenser, then
close the drawer.
4.Press the “Power” button,and choose a programme you need by
turning the knob .
5.Press the “Temp” button and select a wash temperature.
6.Press “ Start/Pause” button to start the washing machine.
7.When the cycle is finished, there is a warning tone sounds.
When washing cycle is finished, the machine will change into standby mode.
And the power will be off after 10 minutes without any control on the control panel.
Main wash compartment
Fabric softener compartment
Pre-wash compartment