Page 4.
ASSEMBLY
*** DO NOT use if damaged. ***
You are now ready to use your
Evo
care
Overbed Table
Overbed Table Assembly
1.
Position column upside down and insert release
lever. (The release rod inside the column should be
visible in the lower portion of the column. If not
shake the column).
2.
The curved side of the of the release lever should
be closest to the top of the table and between the
release rod and the column.
3.
Put table top upside down on a flat surface.
4.
Hold release lever in column and locate into top
bracket
—
align holes
—
install bolts, first through top
bracket, column and release lever, then second
through top bracket and column. Tighten locknuts.
5.
Install a bolt through the bolt plate and column
—
hand tighten
—
repeat for other side.
6.
Put overbed table on its side to ease pressure
on the bolts
—
align column and base and tighten
both bolts.
7.
Remove the shipping screw (top screw) from the column
and replace with Phillips screw provided.
8.
The Overbed Table can now be adjusted to the desired
height.
9.
To RAISE the table top, place your hand underneath
the table top and move it upward to the desired
height. Remove hand pressure to set height.
10.
To LOWER the table top, lift the release lever and
push the table top downward to the desired height.
Let go of the release lever to set height.
(The column locks in place when the release lever is released.)
Summary of Contents for EV5203R5311
Page 2: ......
