INSTALLATION INSTRUCTIONS
A f f i n i t y 3 0 G e
Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA
Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | [email protected]
29
CHECKING TCU AND ELECTRICAL CONNECTIONS
Temperature Sensor Wire
Input Locations
INNER ENC
OUTER ENC
OUTPUTS
OUTER3
OUTER2
OUTER1
INNER
DISPLAY
PCB
K +
OMEGA
MADE IN USA
K +
OMEGA
MADE IN USA
K +
OMEGA
MADE IN USA
K +
OMEGA
MADE IN USA
AC IN
T/C
INPUTS
I
O
O
O
Inner
Outer
Outer
Outer
LCD Ribbon Output Location
HIGH
VOLTAGE
DO NOT ATTEMPT TO CHECK ELECTRICAL CONNECTIONS UNLESS
POWER HAS BEEN DISCONNECTED FROM THE UNIT.
It may be necessary to check connections on the main Temperature Control Unit (TCU) to
ensure the Temperature Sensor wires and LCD Display Ribbon are properly connected and
seated into their sockets. If Inner and Outer wire locations do not correctly correspond to the
locations shown on the TCU and cook surface, the system will malfunction.
The diagram above shows the locations for the respective temperature sensor and LCD
display connections on the TCU. Refer to pages 17 and 18 for respective TC wire connection
locations on the underside of the cooking surface. To access the TCU, remove the lower front
panel on the chassis and gently pivot the TCU bracket from underneath the chassis.
