EVL PRO SCAN 150-250, User Manual

Page: 10 / 24

CLLT
ON/OFF Clear lamp time
STEP
S-01 ~ S- 48 Steps of Program Run
C-01 ~ C-30
01XX (00~FFH)
30XX (00~FFH) Edit the channels of each
scene
TIME (sec.) T - - X (1~ 9) Time for each scene
4 E DI T
SC 01
~
SC 48
CNIN ON/OFF Edit program via controller
Main functions
- Main menu 0
1. Press
[ENTER]
for 3 seconds to enter the main menu
"M ODE "
(display flashing)
2. Press
[ENTER]
and select
"ADDR"
,
' RUN'
or
"DISP"
by pressing
[UP]
button.
3. Press
[ENTER]
for selecting the desired sub menu.
address setting, Slave setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Select
' VALU'
by pressing
[UP]
button.
2. Press
[ENTER]
, adjust the DMX address by pressing
[U P]
or
[DN]
.
3. Press
[ENTER]
to confirm.
4. Press
[EX I T/DN]
in order to return to main menu.
With this function, you can define the device as slave.
1. Select
'SLAV '
by pressing
[UP]
button.
2. Press
[ENTER]
, the display shows
'ON '
or
'OFF'
.
3. Press
[UP]
to select
'ON '
if you wish to enable this function or
'OFF '
if you don' t.
4. Press
[ENTER]
to confirm.
5. Press
[EXI T/DN]
in order to return to the main menu.
With the function
"RUN"
, you can run the internal program. You can set the number of steps under Step. You
can edit the individual scenes under Edit. You can run the individual scenes either automatically (AUTO), i.e.
with the adjusted Step-Time or sound-controlled (SOUN). The selection "ALON" means Stand Alone-mode and
"MAST" that the device is defined as master.
9
DMX address setting, Slave setting
/
DMX address setting.
Slave setting.
Program Run, Master setting