Evinrude E-Tec 40 HP, Service Manual

Page: 69 / 426

67
ENGINE MANAGEMENT MODULE (EMM)
DIAGNOSTIC SOFTWARE FUNCTIONS
4
Powerhead Break-In
Use the diagnostics software to start break-in oil-
ing after a powerhead rebuild. The break-in oiling
program runs for two hours of outboard operation,
above 2000 RPM.
Tiller/Remote Programming
This feature con trols the start in ge ar prot ection
function of the neutral switch. Tiller operated mod-
els, including remote models with an installed tiller
conversion kit, MUST be set to TILLER.
Ignition Timing
Use the
Ignition Timing
scre en to check an d
adjust
EMM
timing.
EMM
timing must be synchro-
nized to crankshaft position.
Refer to
TIMING ADJUSTMENTS
on p. 113.
Check timing af ter any of the following proce-
dures:
•
Powerhead replacement
•
Crankshaft replacement
•
Flywheel removal or replacement
•
CPS replacement
•
EMM
replacement
•
EMM
software replacement
IMPORTANT:
Make sure the timing poin ter is
set and the outboard reaches operating tempera-
ture before making adjustments.
1. Break-in oil setting
008580
1. Starter mode setting
008580
1
1
008572