Evinrude E-TEC 200, Service Manual

Page: 28 / 416

26
ROUTINE SERVICE
OETIKER CLAMP SERVICING
OETIKER CLAMP
SERVICING
Clamp Identification
Use Oetiker clamps for making hose connections.
These clamps provide corrosion resistance, mini-
mize the potential for abrasion of rigging compo-
nents, and provide solid, permanent connections.
The selection and installation of an Oetiker clamp
is essential in the proper sealing of hose connec-
tions. The clamp identification numbers appear on
the side of the clamp, near the top of the ear.
Refer to
Clamp Selection chart for dimensions.
Clamp Selection
To select the correct size Oetiker clamp, measure
the outside diameter of the hose when installed on
the fitting.
Chose a clamp so that the outside diameter of the
hose is approximately in the middle of the clamp-
ing range of the clamp.
WARNING
DO NOT re-use Oetiker clamps. Fuel leak-
age could contribute to a fire or explosion.
1. Clamp identification numbers 000093
1
' ,
P P
K F Q L
H V R +
U H W H P D L '
1 3
H J Q D 5 J Q L S P D O &
008458