12
2551868A
Hydraulic connections
Connection arrangement.
Ensure that the hydraulic connections of the pipework piped up to the unit are
correct and follows the hydraulic schematic. The manufacturer cannot accept any
responsibility for any damage caused to the unit due to crossed connections.
Any Evinox engineer callout/visit due to this issue will be chargeable.
The ModuSat® heat interface unit is designed to be wall mounted or floor standing with the typical
primary connections and domestic water hydraulic connections as shown below.
The Evinox Energy flushing by-pass valve kit should be installed before connecting the unit to the
network.
Isolation valves should not be opened until system is flushed.
The whole primary system should be cleaned and flushed in accordance to BG29/2012 before
installing the heat interface unit to ensure the ModuSat® unit is not damaged.
Wall fixing
There are two ModuSat® CHHC unit configurations: floor standing or
wall mounted. Wall mounted HIU can be installed on the wall bracket or
wall frame, both provided by Evinox.
Wall bracket
Wall frame
Wall fixing
Installer must ensure that appropriate fixings are used.
