EVGA SR-3 DARK (160-CX-W999)
- 71 -
In the “SATA Mode Selection” at the top, the default will be AHCI. Click on the arrow
to the right side of AHCI or navigat
e to it with your keyboard and press “Enter” to
open the pulldown menu. Select RAID from the list.
RAID mode not only includes the RAID controls, but also shares the same
options/functions/commands as AHCI; you may continue using your AHCI devices
normally when the SATA Configuration is set to RAID mode.
The SATA Information menu shows a list of all drives currently detected by the
controller; make sure the list in your BIOS matches what you have plugged in. If it does
not, reseat cables on the device(s) in question. If the issue persists, please check the
troubleshooting section on Page 148.
Once RAID is enabled and all devices are detected, press F10 to save and exit. Upon
reboot, repeatedly press “Delete” to reenter the BIO
S. Once in the BIOS, go back to
the “Advanced” tab where you’ll find new item
s
at the bottom of the list called “Intel
®
VROC sSATA Controller
”
and “Intel® VROC SATA Controller.”
