FITTINGS
Install a male plug on the tool which is free flowing and which will release air pressure from the tool when disconnected
from the supply source.
HOSES
Air hoses should have a minimum of 10.6 bar (150 PSI ) working pressure rating or 150 percent of the maximum pressure
that could be produced in the air system. The supply hose should contain a fitting that will provide “quick disconnecting”
from the male plug on the tool.
SUPPLY SOURCE
Use only clean, regulated compressed air as a power source for this tool. Never use oxygen, combustible gases, or bottled
gases as a power source for this tool as the tool may explode.
REGULATOR
A pressure regulator with an operating pressure of 0 ~ 8.79 bar (0 ~ 125 PSI) is required to control the operating pressure
for safe operation of this tool. Do not connect this tool to air pressure which can potentially exceed 14 bar (200 PSI) as tool
may fracture or burst, causing injury.
OPERATING PRESSURE
Do not exceed recommended maximum operating pressure as tool wear will be greatly increased. The air supply must be
capable of maintaining the operating pressure at the tool. Pressure drops in the air supply can reduce the tool’s driving
power. Refer to “Tool Specifications” for setting the correct operating pressure for the tool.
FILTER
Dirt and water in the air supply are major causes of wear in pneumatic tools. A filter will help to get the best performance
and minimum wear from the tool. The filter must have adequate flow capacity for the specific installation. The filter has to
be kept clean to be effective in providing clean compressed air to the tool.
Consult the manufacturer’s instructions on proper maintenance of your filter. A dirty and/or clogged filter will cause a
pressure drop which will reduce the tool’s performance.
DO NOT USE OXYGEN, COMBUSTIBLE GASES, OR BOTTLED GASES AS A POWER SOURCE FOR
THIS TOOL AS TOOL MAY EXPLODE, POSSIBLY CAUSING INJURY.
OPERATION :
AIR SUPPLY AND CONNECTIONS
C
2
H
2
O
2
12
Summary of Contents for SN41 Series
Page 20: ...20...
