evertz EQT-1616-3G-C, User Manual

Page: 26 / 102

EQT-1616-3G-C-C
EQT 12G/3G/HD Router
Page 14
4.1.2. Rear View
There are a number of communication connections on the rear of the EQT frame. Figure 4-3 identifies all
the connectors on the rear panel. These connectors provide access to the various communications
facilities of the EQT router, such as control and video status monitoring.
Figure 4-3 : Rear Communication Connections on EQT-1616-3G-C Rear Plates
4.2. SYSTEM CONFIGURATION
4.2.1. Setting the IP Address
The EQT-1616-3G-C consists of two individual components, Router and Control Panel, that each have
their own IP address. These components can be accessed through either Ethernet or Serial ports, both
on the rear panel of the device.
When shipped from factory, the default IP addresses of the devices are as follows:
Router Component (EQT): 192.168.245.17
Control Panel Component: 192.168.245.18
4.2.1.1. To change the IP address of the components via Ethernet
For the EQT:
1. Telnet to port 23 of the EQT IP address
2. Log in using login/password combination customer/customer
3. Once the configuration menu is displayed, select the Network Setup menu
4. Follow the on-screen instructions to set the IP address, subnet mask, gateway, and broadcast
address
5. Make sure to select the option to Save and Exit when changes are complete
6. Wait 30 seconds for changes to be applied
7. Reboot the EQT for changes to take effect
For the Control Panel:
1. Telnet to port 23 of the Front Panel IP address
2. Once the configuration menu is displayed, select the Network Setup menu
3. Follow the on-screen instructions to set the IP address, subnet mask, gateway, and broadcast
address
4. Make sure to select the option to Save and Exit when changes are complete
5. Wait 30 seconds for changes to be applied
6. Reboot the EQT for changes to take effect
HDBNC(Inputs/Outputs)
Ethernet
Ports
DB-9 Serial Ports
GPIO
Reference In/Loopout
Aux I/O
Power Supply Status LED
Power Supply Status LED
AC Power Supply
AC Power Supply