7882DM2-LB4-CA2-ASI Series
DVB-S/S2/S2X Satellite Demodulator
Page - 4
Revision 1.0
2.2.
HARDWARE INSTALLATION
Before handling the card it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap be worn. Locate on the 7800 chassis two adjacent vacant
slots. Unpack the 7882DM2-LB4-CA2-ASI and separate the rear panel from the main card. Locate on
the rear of the rack an empty slot and remove the blanking panels. Insert the rear panel into the back of
the chassis and secure using the screws provided.
Before inserting the front card, connect the serial cable provided to the board. Now insert the 7882DM2-
LB4-CA2-ASI Series card into the corresponding front slots ensuring the card lines up with the slot
runners on the bottom and the top of the chassis. Push the card into the slot ensuring that when it
mates with the rear card that it has been firmly pushed into a seated position. This can be confirmed
when the connectivity lights for the Ethernet port are illuminated. Do not connect any cables to the rear
card until the initial configuration has been completed (failure to do this could cause unwanted network
issues).
2.3.
CONFIGURATION OF MANAGEMENT IP CONNECTION
The first step is to configure the management IP connection so that the customer can create
management access to the unit via the user’s Local Area Network. The user can change the
management IP address from the serial port of the frame controller by following the steps below.
1. Remove the panel by unscrewing both knobs on the side.
2. Connect the serial upgrade cable (ribbon cable) provided by Evertz to the 2x3 header at the
front edge of the 7801FC/7800FC.
3. Open a terminal program such as HyperTerminal. Setup the terminal program as shown in
Figure
2-2 : COM Port Settings
4. Power on the unit and allow unit to boot up.
5. After boot up, press <
ENTER>
and the Login screen will appear. Enter login:
customer
and
password:
customer
6. After logging in, the Main Menu will appear in the terminal window as shown in Figure
