7800 Multiframe Manual
7825DSK2-LG(-HD)(-3G) 3G/HD/SD Dual Downstream Keyer
Page 4-24
Revision 2.0
VLPRO OPERATION
4.12. PRESETS TAB
The 7825DSK2-LG(-HD)(-3G) has 10 user presets that can store pre-defined configurations for such
things as Matte settings, Transition settings and DSK settings. The parameter values stored are the
menu settings that are currently based on the status of the Program Bus. Therefore, if you would like
to store a preset that has a 2.35 matte applied, you must first configure the “Matte Aspect” and “Matte
Enable” options, and then store the preset at one of the user preset addresses. When presets are
recalled, the settings are recalled to the Preview Bus and will not show on the Program Bus until the
DO TRANSITION
button is pressed, or a GPI trigger invokes the transition.
The
PRESET
setup
window is used to store and recall user presets.
After upgrading the 7825DSK2-LG(-HD)(-3G) with new firmware, all presets should
be recalled using the Recall Preset menu item, the values for new features must be
set, and the preset must be saved again using the Store Preset menu item.
IF THIS IS NOT DONE, OLD PRESETS COULD BE RECALLED WITH UNDESIRABLE
SETTINGS.
Figure 4-13: Presets Window
PRESET:
Using the drop down menu, select the preset number to store or recall.
RECALL:
This item is used to recall 1 of the 10 user presets to the Preview Bus.
STORE PROGRAM:
This item is used to store the Program Bus settings to 1 of the 10 user presets.
Select
Store Program
to use the Program Bus as the source of the preset
settings.
STORE PREVIEW:
Select
Store Preview
to use the Preview Bus as the source of the preset
settings.
EXPORT:
This menu item is used to send the settings to 1 of the 10 user presets to the
console serial port (UPGRADE 232) as ASCII text. This function is useful in
archiving the settings of the presets or for diagnostic purposes.
