7780M4-ASI / 7780D4-ASI
Quad ASI TDM-Mux/Demux
Revision 1.0
Page
5
2.2. HARDWARE
INSTALLATION
The following materials are required to successfully install the 7780M4-ASI and 7780D4-ASI modules:
1. 1 Spare slot in an Evertz 7700 frame with Frame Controller
2. Evertz serial cable
3. VLPro Server IP address
Before handling the card it is important to minimize the potential effects of static electricity. It is
therefore recommended that an ESD strap be worn.
Unpack your 7780M4-ASI and/or 7780D4-ASI and separate the rear card from the main card. Locate
the blank plates on the rear of the rack and remove a single blanking panel. Insert the rear plate into
the back of the chassis and secure using the two screws provided.
Figure 2-2: Rear View of 7700FR Frame
Before inserting the front card, connect the serial cable to the board using the serial cable provided.
Now insert the 7780M4-ASI and/or 7780D4-ASI card into the corresponding front slots ensuring the
card lines up with the slot runners on the bottom and the top of the chassis. Push the card into the slot
ensuring that when it mates with the rear card that is has been firmly pushed into a seated position.
