7708VB-8-HSE User Manual
8 SDI/ASI or 6 HD-SDI plus Ethernet Fiber Transceiver
Page - 14
Revision 0.1
4.3.3. Displaying the Output Video Standard
To display the video output standard from the
STAT
menu, use the shaft encoder/pushbutton to select
the
VOUT
menu item and then choose the desired video channel
VO1
to
VO8
. The following
indications are possible:
1080I-60
1080P-24
720P-50
1080I-59.94
1080P-23.98
1080P-60
1080I-50
1080P-25
1080P-59.94
1035I-60
1080P-30
ASI
1035I-59.94
1080P-29.97
525I
1080I-48
720P-60
525I-SDTI
1080I-47.96
720P-59.94
625I
1080I-60
STAT
LOS
Loss of Signal – A valid output is not present.
DENY…STD
Denied due to Standard Restriction – This message is
indicated if the applied signal does not match the permitted
standard for the input, as configured by the CTRL/VID/STD
menu items.
DENY…PSWD
Denied due to Password Restriction – This message is
indicated if the output is password-protected, as configured
by the CTRL/PSWD menu items.
DENY…MON
Denied due to Monitoring Channel (Video 8 only) – This
message may be indicated only for Video input 8 when this
channel is used as a monitoring channel, as configured by
the CTRL/VID/MON menu item.
UKNOWN
Unknown Signal – An output is present, but the format is
not recognized.
VOUT
VO1-VO8
LOS
DENY…STD
DENY…PSWD
DENY…MON
4.3.4. Displaying the Receiver Optical Power
Menu selection can display the received optical power detected by the XFP module in (dBm). To
display the received power from the
STAT
menu, use the shaft encoder/pushbutton to select the
OPTO
menu item and then choose the
RXP
menu item.
STAT
The following indications are possible:
-30
to
+8
Optical Power (dBm).
LOW
Optical Power Low – Power is below –30dBm.
OVER
Optical Power Over – Power is over the specified maximum
(damage may occur).
NA
Not Available – Pluggable XFP module not detected.
OPTO
RXP
Values from
XFP
LOW
OVER
NA
