3505 Frame Manual
3505FR Series Fiber Optic SFP Frame
Page - 44
Revision 1.2
VISTALINK
®
6.3.
VISTALINK
®
TRAPS
The following traps can be enabled and monitored through the VistaLINK
®
interface.
Parameter
Description
Rx Optical Power High 1
Monitors high optical input on channel 1
Rx Optical Power High 2
Monitors high optical input on channel 2
Rx Optical Power Low 1
Monitors low optical input on channel 1
Rx Optical Power Low 2
Monitors low optical input on channel 2
No Input Detected 1
Monitors video input on channel 1
No Input Detected 2
Monitors video input on channel 2
Reclocker Loss 1
Monitors reclocking status on channel 1
Reclocker Loss 2
Monitors reclocking status on channel 2
Tx Laser Fault 1
Monitors laser 1 health
Tx Laser Fault 2
Monitors laser 2 health
SFP Communication Loss
Monitors SFP communication with frame controller
Fan Bad
Monitors health of fan #1 of 3505FM unit
PSU 1 Fail
Monitors health of upper 3505PS unit
PSU 2 Fail
Monitors health of lower 3505PS unit
External Power 1 Fail
Monitors the presence of AC power to DC inlet #1
External Power 1 Fail
Monitors the presence of AC power to DC inlet #2
Table 6-2: VistaLINK
®
Traps
6.4.
VISTALINK
®
CONTROLLED PARAMETERS
The following parameters can be controlled via the VistaLINK
®
interface.
Parameter
Description
IP Address
Sets IP Address.
Subnet Mask
Sets Subnet Mask.
Gateway Address
Sets Gateway Address.
Broadcast Address
Sets Broadcast Address.
Reboot
Reboots the 3505FR frame.
Frame Controller Trap Destination
Defines the IP address where SNMP traps will be sent to.
Trap Resend
Resends the current traps state.
Low Optical Threshold
Sets the Input Optical Power Threshold.
Inversion
Sets the Inversion.
Squelch
Sets the Output Squelch mode.
Swap Channel
Sets the Channel Swap mode.
Slew Feature
Sets the Output Slew rate.
Table 6-3: VistaLINK
®
Controlled Parameters
