7
Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
When the bucket is full, the unit will automatically
stop running, and the Full indicator light will flash.
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the floor
because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water
to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for
the dehumidifier to operate.
The machine will re-start when the bucket is restored
in its correct position.
NOTES:
When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
2. Continuous draining
Fig.5
Fig.6
Fig.7
1. Pull out the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
3. Pour the water out.
Water can be automatically emptied into a floor
drain by attaching the unit with a water hose
( 12mm) (not included).
NOTE:
When the continuous drain feature is not
being used,remove the drain hose from the outlet
and attach the rubber plug back to the drain outlet.
Pull out the rubber plug from the drain outlet in the back of the unit.
Insert the water hose into the unit from the drain outlet in the
back of the unit as shown in Fig.8. Attach the water hose to the
drain hose outlet of the unit.Make sure the connection of the water
hose and the drain hose outlet of the unit is tight and do not let the
water leak.
Then lead the water hose to the floor drain or a suitable drainage
facility.The drainage facilify should be lower than the drain outlet
of the unit.
Be sure to run the water hose sloping downward and let the
water to flow out smoothly.Do not install the water hose as
shown in Fig.9a and Fig.9b.
OPERATING THE UNIT
Fig.9a
Fig.9b
Do not block water flow by a rise.
Do not block water flow by a retortion.
Insert the water
hose from the
drain outlet
Pull out the
rubber plug
Fig.8
