• 10 •
9. STORAGE INSTRUCTIONS
1. Charge battery to full capacity before storage.
2. Store this unit at temperatures between -4°F-+140°F (-20°C-+60°C).
3. Never completely discharge the battery.
4. Charge after each use.
5. Charge at least once every month, if not in frequent use, to prevent
over-discharge.
10. TROUBLESHOOTING
PROBLEM
REASON/SOLUTION
The jump starter turns on, but
won’t jump start my vehicle.
Make sure you have pressed the smart
cable’s button.
Verify the charge level of the jump starter is
at least 50%.
Do not attempt to jump start your vehicle
more than three consecutive times. If
the vehicle still does not start, consult a
qualified service technician.
All four LEDs flash.
Low or high temperature. LEDs will stop
flashing when the condition is corrected.
The last LED flashes, then
turns off.
Over-discharge. Recharge the internal
battery.
The green LED on the smart
cable does not light when its
button is pressed.
Check connections.
If an LED is flashing, refer to the table
below. When the condition is corrected,
the smart cable will automatically reset.
Smart Cable LED Behavior
Green LED lit solid
Ready to jump start
Green LED flashes three times Reverse charging protection
Red LED flashes once
Reverse polarity protection
Red LED flashes twice
Short circuit protection
Red LED flashes four times
Low voltage protection
Red LED flashes five times
High temperature protection
Red LED lit solid
OK to press button to jump start
