TSC06-C Gateway User Manual
Page 21 of 25
After the count down, the browser will automatically re-connect to the
homepage of TSC06-C.
When the firmware is writing to the Flash, the power LED will turn on red light.
8.5.2.
In the Boot Time
In the boot time, if TSC06-C found error image that causes boot failure,
TSC06-C will automatically enter the upgrade mode. At this moment, the
connection LED will flash green and red light alternately.
You can manually turn to upgrade mode in boot time. Press the reset button,
and then press the connection button over three times. Check the connection
LED to make sure TSC06-C successfully enters the upgrade mode.
Use the browser to connect to 192.168.1.222.
Figure 25:
The upgrade page in the bootloader runtime.
Choose the firmware file and click the “Mettre a jour” button. It will start to
upload the firmware and write to the flash. It will start to count down. At this
time, the user should not cut off the power of TSC06-C.
